Mining Rig Build Guide－19 GPU

STEP 1 / 安裝 底部VGA顯卡底板 Lower part

1.1 ｜於VGA鐵板（零件編號08）安裝銅柱（零件編號20）

1.1 ｜install copper-pillar on VGA plate.

1.2 ｜於VGA鐵板（零件編號08）上，使用內六角螺絲(短)（零件編號10）以及M4滑塊（零件編號15）組裝出鋁擠條固定點，共7組。

1.2 ｜Use a M4 Hexagon screw A and a M4 insertion nut to compose a fixed point on VGA plate, there will be 7 fixed points needed.

1.3 ｜在此步驟安裝VGA鐵板支撐架；將鋁擠條 60cm（零件編號04）從中間穿過鋁擠條固定點，再將鋁擠條 35cm（零件編號05）由側邊穿過鋁擠條固定點（左右二側皆是），最後對準鎖孔並使用M6螺絲（零件編號24）鎖緊固定鋁擠條 60cm（零件編號04）及鋁擠條 35cm（零件編號05）。

1.3 ｜Complete Assembling a VGA plate in this step. Using one Aluminum Extrusion 60cm goes though the three fixed points in the middle, and using two Aluminum Extrusion 35cm goes though two fixed points on the both side, then using M6 screws to lock up these Aluminum Extrusion bars.

1.4｜完成安裝VGA鐵板支架之後，將VGA鐵板翻回正面，使用M3螺絲（零件編號09）以對角方式固定安裝 PCIe 轉接板。

1.4｜After completing VGA plate assembly, flip the VGA plate over, and using M3 screws to install PCIe x1 to x16 riser card diagonally.

1.5｜於VGA鐵板之左右二側的鋁擠條 35cm（零件編號05）底部之前後二端各安裝一組 L角固定組件（零件編號18），並與鋁擠條外緣切齊，如此可加強結構穩固性。L角固定組件之安裝步驟是利用內六角螺絲(短)（零件編號10）、檔片（零件編號19）將M4滑塊（零件編號15）固定於L角固定塊外側。

1.5｜Using two M4 Hexagon screw B, two gaskets and two M4 Insertion Nuts to assemble a L shaped component. This L shaped component is using to increase Structural stability. Please notice that L shaped component have to be align with the edge of Aluminum Extrusion bar.